The bearing that is not seated has no play., but it will barely spin. My question is just how much play should there be in the rear bearings?ģ axles that appear fully seated in the bearing cup have some side to side play: One bearing was not even seated all the way down into the bearing cup:Ĭompared to a fully seated bearing (confirmed on 3 other axles) I thought maybe the rear bearings had been replaced recently but now. Had some time to work on my IFS axle to prep for rear disks. Other priorities and lack of motivation at times suck. This is just the list I can think off of the top of my head, some of these parts have been sitting in the garage for 2+ years install GM CS130 one wire alternator/mount make new bed rails with integrated nuts to allow top be removeable make new seat brackets and install prelude seats convert IFS rear to discs, install new rear shock mounts and install rear axle Although I'm new to 1st gens, that's just typically how it works.īorrowed this from Dirtco's thread but I have 4 of these to install if the flasher doesn't do the trick:įixing the flasher is just one of many things this POS needs including: If you add a resistor inline with the LED lights to achieve the correct intensity, then it will think an incandescent bulb is still hooked up.įast flashing is typically representative of the system telling you a bulb is out, IE no resistance. Normal incandescent bulbs carry a load, in which the system measures.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |